2009 Yamaha Motorsports FX Nytro RTX Owners Manual - Page 64
2009 Yamaha Motorsports FX Nytro RTX Manual
Page 64 highlights
Periodic maintenance and adjustment 9. Rotate the secondary sliding sheave clockwise and push it so that it separates from the secondary fixed sheave. 1. Secondary sliding sheave 2. Secondary fixed sheave 10. Install the V-belt between the secondary sliding and fixed sheaves. 1. V-belt position adjusting bolt 2. Spacer V-belt position More than 1.5 mm (0.06 in) above the edge From 1.5 mm (0.06 in) above the edge to 0.5 mm (0.02 in) below the edge More than 0.5 mm (0.02 in) below the edge Adjustment Remove spacer 1. V-belt Not necessary (It is correct.) 11. Install the drive guard, and then install the left side cover and the shroud. ESU12832 Add spacer Drive chain housing To check the drive chain housing oil level 1. Place the snowmobile on a level surface and apply the parking brake. 2. Remove the shroud and the right side cover. (See page 44 for removal procedures.) 3. Remove the dipstick, wipe it off with a clean rag, and then screw it back into the filler hole. 7. Tighten the V-belt position adjusting bolts. V-belt position adjusting bolt tightening torque: 10 Nm (1.0 m·kgf, 7.2 ft·lbf) 8. Install the V-belt over the primary sheave assembly. 58