2009 Yamaha Motorsports Phazer GT Owners Manual - Page 68
2009 Yamaha Motorsports Phazer GT Manual
Page 68 highlights
Periodic maintenance and adjustment TIP Apply the parking brake before replacing the V-belt. 1. Remove the left side cover (PZ50 / PZ50RT / PZ50GT / PZ50MT), or open the shroud and remove the left upper cover and the left side cover (PZ50VT). (See page 49 for removal procedure.) Remove the drive guard. Rotate the secondary sliding sheave clockwise and push it so that it separates from the secondary fixed sheave. 1. V-belt wear limit 2. 3. New V-belt width: 34.1 mm (1.34 in) V-belt wear limit width: 32.5 mm (1.28 in) 4. 5. Install the drive guard. Install the left side cover (PZ50 / PZ50RT / PZ50GT / PZ50MT), or install the left side cover and the left upper cover, and then close the shroud (PZ50VT). To replace and adjust the V-belt EWS00421 WARNING G G When installing a new V-belt, make sure that it is positioned properly. Otherwise, the V-belt clutch engagement speed will be changed and the snowmobile may move unexpectedly when the engine is started, which could cause an accident. Have a Yamaha dealer make this adjustment. 1. Secondary sliding sheave 2. Secondary fixed sheave 4. Pull the V-belt up over the secondary fixed sheave. ECS00520 NOTICE To ensure proper clutch performance as the V-belt wears, it is necessary to adjust the gap between the secondary fixed sheave and the secondary sliding sheave by changing the positions of the spacers. Have a Yamaha dealer make this adjustment. 1. V-belt 5. Remove the V-belt from the secondary sheave assembly and primary sheave assembly. 62