2009 Yamaha Motorsports Road Star Silverado S Owners Manual - Page 88
2009 Yamaha Motorsports Road Star Silverado S Manual
Page 88 highlights
MOTORCYCLE CARE AND STORAGE Exposure to the elements can dry out the leather over time. Therefore, an occasional application of a good quality mink oil is recommended to restore the leather and lift its water resistance. Make sure that the saddlebags are clean and dry before applying the mink oil. Using a soft cloth or a dauber, work a thin coat of mink oil into the leather surface of the saddlebags. Wipe off any excess oil immediately and allow the saddlebags to dry for several hours. EAU44451 Storage Short-term Always store your motorcycle in a cool, dry place and, if necessary, protect it against dust with a porous cover. ECA10810 NOTICE G G Storing the motorcycle in a poorly ventilated room or covering it with a tarp, while it is still wet, will allow water and humidity to seep in and cause rust. To prevent corrosion, avoid damp cellars, stables (because of the presence of ammonia) and areas where strong chemicals are stored. 8 Long-term Before storing your motorcycle for several months: 1. Follow all the instructions in the "Care" section of this chapter. 2. Fill up the fuel tank and add fuel stabilizer (if available) to prevent the fuel tank from rusting and the fuel from deteriorating. 8-4 3. Perform the following steps to protect the cylinders, piston rings, etc. from corrosion. a. Remove the spark plug caps and spark plugs. b. Pour a teaspoonful of engine oil into each spark plug bore. c. Install the spark plug caps onto the spark plugs, and then place the spark plugs on the cylinder head so that the electrodes are grounded. (This will limit sparking during the next step.) d. Turn the engine over several times with the starter. (This will coat the cylinder walls with oil.) e. Remove the spark plug caps from the spark plugs, and then install the spark plugs and the spark plug caps. WARNING! To prevent damage or injury from sparking, make sure to ground the spark plug electrodes while turning the engine over. [EWA10951] 4. Lubricate all control cables and the pivoting points of all levers and pedals as well as of the sidestand/centerstand.