2009 Yamaha Motorsports V Star 650 Custom Owners Manual - Page 76
2009 Yamaha Motorsports V Star 650 Custom Manual
Page 76 highlights
PERIODIC MAINTENANCE AND ADJUSTMENT 2. Lift the wheel up between the fork legs. TIP Make sure that there is enough space between the brake pads before inserting the brake disc and that the slot in the speedometer gear unit fits over the retainer on the fork leg. 1. Wheel axle 2. Front wheel axle pinch bolt Tightening torque: Wheel axle: 59 Nm (5.9 m·kgf, 43 ft·lbf) 6. Tighten the front wheel axle pinch bolt to the specified torque. Tightening torque: Front wheel axle pinch bolt: 20 Nm (2.0 m·kgf, 14 ft·lbf) 7 3. Lift the front wheel off the ground according to the procedure on page 7-34. 4. Pull the wheel axle out, and then remove the wheel. NOTICE: Do not apply the brake after the wheel has been removed together with the brake disc, otherwise the brake pads will be forced shut. [ECA11071] EAU24932 7. While applying the front brake, push down hard on the handlebars several times to check if the front fork compresses and rebounds smoothly. 8. Connect the speedometer cable. 1. Speedometer gear unit 2. Speedometer cable 3. Retainer To install the front wheel 1. Install the speedometer gear unit into the wheel hub so that the projections mesh with the slots. 3. Insert the wheel axle. 4. Lower the front wheel so that it is on the ground. 5. Tighten the wheel axle to the specified torque. 7-35