2010 Yamaha Motorsports FX Nytro M-TX SE 162 Owners Manual - Page 22
2010 Yamaha Motorsports FX Nytro M-TX SE 162 Manual
Page 22 highlights
Control functions ESU10691 Auxiliary DC jack The auxiliary DC jack is located in the front panel and can be used for accessories. TIP The auxiliary DC jack cannot be used if the engine is not running. To use the auxiliary DC jack 1. Start the engine. 2. Open the auxiliary DC jack cap, and then insert the accessory power plug into the jack. 1. Headlight beam switch "LIGHTS" 2. High beam "HI" 3. Low beam "LO" ESU10674 Grip/thumb warmer adjustment switch The grip/thumb warmer adjustment switch controls the electrically heated handlebar grips and throttle lever. 1. Auxiliary DC jack cap 2. Auxiliary DC jack 3. 1. Grip/thumb warmer adjustment switch After using the auxiliary DC jack, be sure to remove the accessory power plug from the jack and to close the auxiliary DC jack cap. ECS00120 To raise the temperature To raise the grip warmer temperature, press the " " side of the switch. To raise the thumb warmer temperature, press the " " side of the switch. To lower the temperature Continue to press the switch until the temperature level returns to the minimum level, and then raise the temperature to the desired level. See "Fuel meter and grip/thumb warmer level indicator" on page 12 for detailed information. NOTICE G G Do not use accessories requiring more than the maximum rated capacity for the auxiliary DC jack. This may overload the circuit and cause the fuse to blow. (See page 71 for the specified amperage.) Do not use an automotive cigarette lighter or other accessory with a plug that gets hot because the jack can be damaged. Maximum rated capacity: DC 12 V, 2.5 A (30 W) 16