2011 Yamaha Motorsports Venture Lite Owners Manual - Page 21
2011 Yamaha Motorsports Venture Lite Manual
Page 21 highlights
Control functions To raise the temperature To raise the grip warmer temperature, press the " " side of the switch. To raise the thumb warmer temperature, press the " " side of the switch. ECS00122 NOTICE G To lower the temperature Continue to press the switch until the temperature level returns to the minimum level, and then raise the temperature to the desired level. See "Fuel meter and grip/thumb warmer level indicator" on page 11 for detailed information. ESU10696 G To avoid circuit overload and a possible fuse blowing, do not use accessories requiring more than the maximum rated capacity for the auxiliary DC jack. (See page 77 for the specified fuse amperage.) Do not use an automotive cigarette lighter or other accessory with a plug that gets hot because the jack can be damaged. Maximum rated capacity: DC 12 V, 2.5 A (30 W) Auxiliary DC jack (FX10M53S/FX10M62S) The auxiliary DC jack is located in the front panel and can be used for accessories. ESU13523 Brake lever The snowmobile is stopped by braking the entire drive system. Squeeze the brake lever towards the handlebar grip to stop the snowmobile. TIP The auxiliary DC jack can only be used if the engine is running. To use the auxiliary DC jack 1. 2. Start the engine. Open the auxiliary DC jack cap, and then insert the accessory power plug into the jack. 1. Brake lever TIP When the brake lever is squeezed, the brake light comes on. 1. Auxiliary DC jack cap 2. Auxiliary DC jack 3. After using the auxiliary DC jack, be sure to remove the accessory power plug from the jack and to close the auxiliary DC jack cap. The brake lever is equipped with a position adjuster. To adjust the brake lever position 1. Loosen the locknut. 15