2012 Yamaha Motorsports Grizzly 300 Automatic Owners Manual - Page 94
2012 Yamaha Motorsports Grizzly 300 Automatic Manual
Page 94 highlights
7. Disconnect the hose on the coolant reservoir side, and then drain the coolant from the coolant reservoir. 1 10. Connect the coolant reservoir hose. 11. Pour the recommended coolant into the reservoir to the maximum level mark, and then install the reservoir cap. NOTICE: Mix antifreeze with distilled water only. However, if distilled water is not available, soft water may be used for refilling. Do not use hard water or salt water since they are harmful to the engine. 12. Pour the recommended coolant into the radiator until it is full. Antifreeze/water mixture ratio: 1:1 Recommended antifreeze: High-quality ethylene glycol antifreeze containing corrosion inhibitors for aluminum engines Coolant quantity: Radiator capacity (including all routes): 0.94 L (0.99 US qt, 0.83 Imp.qt) Coolant reservoir capacity (up to the maximum level mark): 0.25 L (0.26 US qt, 0.22 Imp.qt) 8 1. Coolant reservoir hose 8. After draining the coolant, thoroughly flush the cooling system with clean tap water. 9. Replace the coolant drain bolt washer if it is damaged, install the coolant drain bolt, and then tighten it to the specified torque. Tightening torque: Coolant drain bolt: 12 Nm (1.2 m·kgf, 8.7 ft·lbf) 8-22
![](/manual_guide/autos/2012-yamaha-motorsports-grizzly-300-automatic-owners-manual-65cf5ff/94.png)