2012 Yamaha Motorsports Raider S Owners Manual - Page 55
2012 Yamaha Motorsports Raider S Manual
Page 55 highlights
PERIODIC MAINTENANCE AND ADJUSTMENT 12. Pour only 2.5 L (2.6 US qt, 2.2 Imp.qt) of the specified amount of recommended engine oil through the filler hole, insert the dipstick, and then tighten the oil filler cap. 13. Start the engine, rev it several times, and then turn it off. 14. Remove the engine oil filler cap, and then gradually fill the oil tank with the remaining oil quantity while regularly checking the oil level on the dipstick. Recommended engine oil: See page 9-1. Oil quantity: Without oil filter cartridge replacement: 4.10 L (4.33 US qt, 3.61 Imp.qt) With oil filter cartridge replacement: 4.90 L (5.18 US qt, 4.31 Imp.qt) ECA15080 EAU20051 NOTICE ● Transfer case oil The transfer case must be checked for oil leakage before each ride. If any leakage is found, have a Yamaha dealer check and repair the vehicle. In addition, the transfer case oil level should be checked and the oil must be changed by a Yamaha dealer at the intervals specified in the periodic maintenance and lubrication chart. ● In order to prevent clutch slippage (since the engine oil also lubricates the clutch), do not mix any chemical additives. Do not use oils with a diesel specification of "CD" or oils of a higher quality than specified. In addition, do not use oils labeled "ENERGY CONSERVING II" or higher. Make sure that no foreign material enters the oil tank. TIP Be sure to wipe off spilled oil on any parts after the engine and exhaust system have cooled down. 15. Install the engine oil filler cap. 16. Start the engine, and then let it idle for several minutes while checking it for oil leakage. If oil is leaking, immediately turn the engine off and check for the cause. 17. Turn the engine off, and then check the oil level and correct it if necessary. 18. Install the rider seat. 7 7-13