3Com 3C17205 Getting Started Guide - Page 20
Default Settings, Rapid Spanning Tree Protocol
UPC - 000064170930
View all 3Com 3C17205 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
20 CHAPTER 1: INTRODUCING THE SUPERSTACK 3 SWITCH 4400 Default Settings WARNING: When an Expansion Module is not installed, ensure the blanking plate is fitted by tightening all screws with a suitable tool. Table 5 shows the default settings for the Switch 4400: Table 5 Default Settings Feature Switch 4400 Automatic IP Configuration Enabled Port Status Enabled Port Speed 10/100 Mbps ports are auto-negotiated TR-RJ ports (3C17210) are fixed at 100 Mbps Duplex Mode All fixed 10BASE-T and 100BASE-TX ports are auto-negotiated 100BASE-FX ports default to full-duplex mode (100 FD) and must be manually set to half-duplex mode (100 HD) if required. Power over Ethernet Enabled (3C17205 only) Flow Control ■ Enabled in half-duplex mode ■ Auto-negotiated in full-duplex mode Broadcast Storm Control Enabled Virtual LANs (VLANs) All ports belong to the untagged Default VLAN (VLAN 1) with IEEE Std 802.1Q-1998 learning operational Link Aggregation Control Protocol (LACP) Disabled per port IP Multicast Filtering Filtering enabled Rapid Spanning Tree Protocol Enabled Fast Start ■ Enabled on front panel ports ■ Disabled on rear panel port RMON Alarm Enabled Smart Auto-Sensing Enabled Webcache Support Disabled Traffic Prioritization All ports prioritize NBX VoIP traffic (LAN and IP). All ports set to "best effort" for all other traffic. Port Security Disabled per port Configuration Save and Restore Disabled