3Com 3CBLSG24PWR User Guide - Page 16

16 CHAPTER 1: GETTING STARTED LED Status Indicators The 2924-PWR SFP Plus 24-Port Ethernet switch provides LED indicators on the front panel for your convenience to monitor the switch. Table 2 describes the meanings of the LEDs. Table 2 Description on the LEDs of the Switch 2924-PWR LED Power Label Power 10/100/1000 BASE-T Ethernet port status Link/ Activity Duplex mode Duplex 1000Base SFP SFP port status Module Active PoE status PoE Status Status Green Yellow OFF Green Yellow OFF Yellow OFF Green OFF Green OFF Description The switch starts normally. The LED flashes when the system is performing power-on self test (POST). The system has failed the POST. The switch is powered off. The port works at the rate of 1000 Mbps; the LED flashes quickly when the port is sending or receiving data. The port works at the rate of 10/100 Mbps; the LED flashes quickly when the port is sending or receiving data. The port is not connected. The port is in full duplex mode. The port is not connected, or is in half duplex mode. The SFP module is inserted. The SFP module is not inserted or is not recognized. Delivering power. The LED flashes if a fault occurs. Not delivering power.