3M 17304 Installation Guide - Page 1

To Apply 17304 command.com 1 2 3 4 CLEAN surface with isopropyl rubbing alcohol, wipe gently, let dry. Do not use household cleaners. SEPARATE strips. RED SIDE REMOVE RED liner. PRESS adhesive to bundlers. BLACK SIDE REMOVE BLACK liner. 30 SECONDS Press bundler FIRMLY for 30 seconds. Wait 1 hour before use. To Remove 1 NEVER pull strip towards you. 2 STRAIGHT DOWN S L 3 O W L Y 12" 30 cm Hold bundler gently to prevent bundler from snapping fingers. DO NOT press bundler against wall. STRETCH STRAIGHT DOWN ALONG WALL AT LEAST 12 INCHES (30 cm) until strip releases from wall. IMPORTANT: Failure to follow instructions carefully may cause damage! SAVE INSTRUCTIONS for damage-free removal or visit command.com For questions, ideas and special offers go to command.com CAUTION: DO NOT use with wallpaper. May not adhere well to vinyl surfaces. DO NOT use for antiques, heirlooms, or other valuable or irreplaceable items. DO NOT hang items over beds. NOTE: Apply to surfaces above 50°F (10°C). Adhesive could lose adhesion above 105°F (40°C). Not intended for picture hanging. Instead use Command™ Picture Hanging Strips, Sawtooth or Wire-Backed Hangers. Bundlers can be reused with Command™ Medium Strips. The following statements only apply to products distributed in the USA. Limited Warranty: This 3M product will be free from defects in material and manufacture. If this product is defective, your exclusive remedy shall be, at 3M's option, replacement of the product or refund of the purchase price. Limitation of Liability: 3M will not be liable for any loss or damage arising from this product, whether direct, indirect, special, incidental or consequential.