3M SCP740 Operation Guide - Page 20

Powering On/Off the Projector

Get 3M SCP740 PDF manuals and user guides View all 3M SCP740 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

3M™ Super Close Projection System Installation Test Pattern Powering On/Off the Projector Powering On the Projector 1. Ensure that the power cord and signal cable are securely connected. The Power LED will turn red. 2. Turn on the lamp by pressing "Power/Standby" button on the control panel. And the Power LED will turn blue. 3. Turn on your source (computer, notebook, video player, etc.). The projector should automatically detect your source within "Management" menu; check that "Input Source" has been set to "Auto Searching".  To access the built-in test pattern, please press the "Blank" button, then up arrow.  If you connect multiple sources at the same time, use the "Source" button on the control panel or direct source key on remote control to switch. • T urn on the projector first and then the signal 1 sources. 1 Power/Standby © 3M 2008. All Rights Reserved. 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
© 3M 2008.
All Rights Reserved.
15
3M™ Super Close Projection System
Installation
Powering On the Projector
1. Ensure that the power cord and signal cable are securely
connected. The Power LED will turn red.
2. Turn on the lamp by pressing “Power/Standby” button on the
control panel.
And the Power LED will turn blue.
3. Turn on your source (computer, notebook, video player,
etc.). The projector should automatically detect your source
within “Management” menu; check that “Input Source” has
been set to “Auto Searching”.
To access the built-in test pattern, please press the “Blank”
button, then up arrow.
If you connect multiple sources at the same time, use the
“Source” button on the control panel or direct source key on
remote control to switch.
Powering On/Off the Projector
Power/Standby
•
Turn on the
projector first and
then the signal
sources.
Test Pattern
1
1