3Ware 7006-2 Installation Guide - Page 11
Hardware Installation
UPC - 693494700626
View all 3Ware 7006-2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Hardware Installation Hardware Installation Warning: Before proceeding with hardware installation, read the Before You Begin section that completely describes personal and system precautions. Failing to do so may result in personal injury or damage to your computer or the Escalade ATA RAID Controller. To remove an existing Escalade ATA RAID Controller 1 If the computer is running, shut it down. Turn off power to the computer and disconnect the power cord from the outlet. 2 Open the computer case according to the manufacturer's instructions. 3 Disconnect the disks from the existing Escalade ATA RAID Controller installed in your system. If your boot disk is connected to the ATA RAID Controller and you intend to retain it as your boot device, note or mark which physical disk is connected to slot 0 on the controller. This disk should be reconnected to slot 0 on the new ATA RAID Controller. Preserving the slot order of how the other drives are connected is unimportant, even if the disks are part of a disk array. However, it is recommended that a plug-to-plug replacement is followed. 4 Remove the screw in the metal bracket at the end of the old ATA RAID Controller. Save the screw for installing the new controller. 5 Gently remove the ATA RAID Controller from the PCI slot. 6 Remove the cables from theATA RAID Controller and discard. Reusing interface cables is not recommended. www.3ware.com 13