AEG HC452400EB Product Manual - Page 15

Problem, Possible cause, Remedy

Page 15 highlights

ENGLISH 15 Problem Possible cause Remedy The sensor fields become hot. The cookware is too large or Put large cookware on the you put it too near to the rear zones if possible. controls. There is no signal when you touch the panel sensor fields. The signals are deactivated. Activate the signals. Refer to "Daily use" chapter. comes on. Automatic Switch Off oper- Deactivate the hob and acti- ates. vate it again. comes on. The Child Safety Device or Refer to "Daily use" chapter. the Lock function operates. comes on. There is no cookware on the Put cookware on the zone. zone. The cookware is incorrect. Use the correct cookware. Refer to "Hints and tips" chapter. The diameter of the bottom of the cookware is too small for the zone. Use cookware with correct dimensions. Refer to "Technical information" chapter. The cookware does not cov- Cover the cross / square er the cross / square. fully. and a number come on. There is an error in the hob. Disconnect the hob from the electrical supply for some time. Disconnect the fuse from the electrical system of the house. Connect it again. If comes on again, speak to an Authorised Service Centre. comes on. The electrical connection is Speak to a qualified electriincorrect. The supply voltage cian to check the installation. is out of range.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

Problem
Possible cause
Remedy
The sensor fields become
hot.
The cookware is too large or
you put it too near to the
controls.
Put large cookware on the
rear zones if possible.
There is no signal when you
touch the panel sensor
fields.
The signals are deactivated.
Activate the signals.
Refer to "Daily use" chapter.
comes on.
Automatic Switch Off oper-
ates.
Deactivate the hob and acti-
vate it again.
comes on.
The Child Safety Device or
the Lock function operates.
Refer to "Daily use" chapter.
comes on.
There is no cookware on the
zone.
Put cookware on the zone.
The cookware is incorrect.
Use the correct cookware.
Refer to “Hints and tips”
chapter.
The diameter of the bottom
of the cookware is too small
for the zone.
Use cookware with correct
dimensions.
Refer to “Technical informa-
tion” chapter.
The cookware does not cov-
er the cross / square.
Cover the cross / square
fully.
and a number come on.
There is an error in the hob.
Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If
comes on again, speak
to an Authorised Service
Centre.
comes on.
The electrical connection is
incorrect. The supply voltage
is out of range.
Speak to a qualified electri-
cian to check the installation.
ENGLISH
15