AEG L6227FL Product Manual - Page 14
the delay start is active
View all AEG L6227FL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
14 www.aeg.com 10.10 Interrupting a programme and changing a function You can change only some options before they operate. 1. Press button Start/Pause. The related indicator flashes. 2. Change the function set. 3. Press the button Start/Pause again. The programme continues. 10.11 Cancelling a programme 1. Turn the programme knob to to cancel the programme. 2. Turn again the programme knob to a new washing programme. At this time you can also set the available functions. Before starting the new programme the appliance drains the water. Make sure that the detergent is still in the detergent compartment, if not fill the detergent again. 10.12 Opening the door when the programme operates CAUTION! If the temperature and level of the water in the drum are too high, the door lock indicator stays on and you cannot open the door. To open the door proceed as follows: 1. Press the button On/Off for some seconds to deactivate the appliance. 2. Wait for some minutes and then open carefully the appliance door. 3. Close the appliance door. 4. Activate the appliance and set the programme again. 10.13 Opening the door when the delay start is active While the delay start operates, the appliance door is locked. To open the appliance door: 1. Press button Start/Pause. In the display the door lock indicator goes off. 2. Open the appliance door. 3. Close the door and press button Start/Pause. The delay start continues. 10.14 End of cycle When the programme has finished, the appliance stops automatically. The acoustic signal operates (if it is active). In the display comes on and the door locked indicator goes off. The indicator of Start/Pause button goes off. 1. Press button On/Off to deactivate the appliance. After five minutes from the end of the programme, the energy saving function automatically deactivates the appliance. When you activate the appliance again, the display show the end of the last set programme. Turn the programme knob to set a new cycle. 2. Remove the laundry from the appliance. 3. Make sure that the drum is empty. 4. Keep the door ajar, to prevent mildew and odours 5. Close the water tap. 10.15 Draining water out after end of cycle The washing programme is completed, but there is water in the drum: The drum turns regularly to prevent the creases in the laundry. The door lock indicator door stays locked. is on. The You must drain the water to open the door: 1. If necessary, decrease the spin speed. 2. Press the Start/Pause button.