AEG L85275XFL Product Manual - Page 30

30 www.aeg.com Problem Possible cause The appliance fills The end of the drain with water and hose is too low. drain immediately. The washing re- The detergent you used sults are not satis- was not sufficient or cor- factory. rect. You did not remove the stubborn stains before you wash the laundry. Incorrect temperature was set. Too much laundry load. After the check, activate the appliance. The programme continues from the point of interruption. If the problem occurs again, contact the service centre. If the display shows other alarm codes, contact the service centre. Possible solution Make sure that the drain hose is in the correct position. Increase the detergent quantity or use a different one. Use special products to remove the stubborn stains. Make sure that you set the correct temperature. Decrease the laundry load.