AEG L87695WD Product Manual - Page 26

26 www.aeg.com USING THE APPLIANCE - WASHING & DRYING NON-STOP PROGRAMME WASHING & AUTOMATIC DRYING CAUTION! Do not put a plastic device/ball for the detergent into the drum. • Press button 1 to activate the appliance. • Load the laundry. • Measure out the detergent and fabric conditioner. • Turn the programme dial to the wash- ing programme. The display shows the symbols of the different washing phases. CAUTION! Do not set a spin speed lower than the automatic speed of the set programme. • Set the available options. • Press the button 8 until the black line appears under one of the dryness level symbol. The iron dry level comes on The cupboard dry level comes on. The extra dry level comes on. The drying symbol comes on. The anti-crease symbol comes on. The time value on the display is the duration of the washing + drying cycles calculated on a default load size. • Press button 6 to start the programme. The set dryness level symbol stays on. The others level symbols go off. The door locked symbol comes on. The display shows the new time value each minute. The last minutes of the drying cycle the appliance performs the anti-crease and the cooling phases. • When the programme is completed, the appliance stops automatically. • The acoustic signals operate. • When the symbol can open the door. goes off, you • Remove the laundry from the appliance. Make sure that the drum is empty. • Close the water tap. • Keep the door ajar, to prevent mildew and odours. NON-STOP PROGRAMME WASHING & TIMED DRYING CAUTION! Do not put a plastic device/ball for the detergent into the drum. • Press button 1 to activate the appliance. • Load the laundry. • Measure out the detergent and the fab- ric conditioner. • Turn the programme dial to the wash- ing programme. The display shows the symbols of the different phases of the washing cycle. Do not set a spin speed lower than the automatic speed of the set programme. • Set the available options. • Press the button 5 to set the drying time value. The drying symbol comes on. The anti-crease symbol comes on. The drying time symbol comes on. • The display shows the set drying value time.