AEG S73400CTS1 Product Manual - Page 19
Location, Rear Spacers, Levelling
View all AEG S73400CTS1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
LOCATION 100 mm min A B 20 mm REAR SPACERS 2 1 4 3 LEVELLING (1*/,6+ 19 The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm . Ideally, however, the appliance should not be positioned below overhanging wall units. Accurate levelling is ensured by one or more adjustable feet at the base of the cabinet. WARNING! It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation. You can find the two spacers in the bag with documentation. Do these steps to install the spacers: 1. Release the screw. 2. Engage the spacer below the screw. 3. Turn the spacer to the right position. 4. Tighten again the screws. When placing the appliance ensure that it stands level. This can be achieved by two adjustable feet at the bottom in front.