AEG SKS71200F0 Product Manual - Page 11

ENGLISH 11 Problem Possible cause Solution The compressor does not start immediately after pressing the COOLMATIC switch, or after changing the temperature. This is normal, no error has occurred. The compressor starts after a period of time. Water flows on the During the automatic de- This is correct. rear plate of the re- frosting process, frost de- frigerator. frosts on the rear plate. Water flows into the The water outlet is clog- Clean the water outlet. refrigerator. ged. Products prevent that wa- Make sure that products ter flows into the water do not touch the rear collector. plate. The temperature in Many products are stored Store less products at the the appliance is too at the same time. same time. low/high. The temperature in There is no cold air circu- Make sure that there is the refrigerator is lation in the appliance. cold air circulation in the too high. appliance. Upper or lower square is shown in the temperature Display. An error has occurred in measuring the temperature. Call your service representative (the cooling system will continue to keep food products cold, but temperature adjustment will not be possible). dEMo appears on the Display. The appliance is in demonstration mode (dEMo). Keep pressed approximately 10 sec. the OK button since a long sound of buzzer is heard and the Display shut off for a short while: appliance start works regularly. The buzzer sounds. The door is not closed The Display is red. correctly. Refer to "Door open alarm". 6.1 Replacing the lamp The appliance is equipped with a longlife LED interior light. Only service is allowed to replace the lighting device. Contact your Service Center. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact the Service Center. 6.2 Closing the door 1. Clean the door gaskets.