AEG T7DEE845R User Manual - Page 22

22 www.aeg.com Use a moist cloth to clean. Dry the cleaned surfaces with a soft cloth. CAUTION! Do not use furniture cleaning agents or cleaning agents which can cause corrosion. 11. TROUBLESHOOTING 10.6 Cleaning the airflow slots Use a vacuum cleaner to remove fluff from the airflow slots. WARNING! Refer to Safety chapters. 11.1 Error Codes The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to the table). If the problem persists, contact the Authorised Service Centre. WARNING! Deactivate the appliance before carrying out any check. In case of major problems, the acoustic signals operate, the display shows an alarm code and the Start/Pause button may flash continuously: Possible cause Possible cause Remedy Appliance Motor overloaded. The programme was not comple‐ E5A Too much laundry or entrap in the ted. Remove the laundry from the drum. drum, set the programme and re‐ start the cycle. Internal fail. No communication be‐ The programme was not finished tween electronic elements of the properly or the appliance stoped appliance. too early. Switch the appliance off E97 and on again. If the alarm code appears again, contact the Authorised Service Centre. The mains supply is unstable. When the appliance is showing EH0, please wait until main supply is stable than press start. If the ap‐ EH0 pliance pause the cycle without any indication then press the cycle start. If the warning will occur check the power cord / socket in‐ tegrity or main supply. If the display shows other alarm codes, deactivate and activate the appliance. If the problem continues, contact the Authorised Service Centre. In case of different problem with the Tumble dryer check the table below for possible solutions.