AIWA CDC-Z127 Operating Instructions - Page 3

BASIC OPERATION, AUDIO AND CLOCK ADJUSTMENT PWR/MUTE SEL AUDIO CONTROL i/k DISP SRC BAND Turning the unit on/off • Press PWR/MUTE to turn on the unit. The unit also turns on when you insert a CD. • Press and hold PWR/MUTE until the unit turns off. Note Most operations described in this manual require the unit to be turned on before starting the operation, unless explicitly stated otherwise. Changing the source mode 1 Press SRC. Pressing SRC cycles through source modes in the following order: FM1 (FM2/FM3/AM1/AM2) → CD* → AUX ↑ * "CD" does not appear in the display when there is no CD in the unit. Adjusting the volume 1 Turn AUDIO CONTROL. VOL (volume) indicator flashes. Muting the sound 1 Press PWR/MUTE briefly. MUTE indicator flashes. To restore volume, briefly press PWR/MUTE again. Adjusting sound You can select the following modes for adjusting sound depending on the music you listen to: BASS (low frequencies), TRE (high frequencies), BAL (left/right), FAD (front/ rear) and H-BASS (high bass). 1 Press SEL repeatedly to select the mode to be adjusted. Pressing SEL cycles through the modes. The selected mode's indicator flashes. 2 Turn AUDIO CONTROL to increase/decrease the level or to select on/off for the selected mode. Note Adjust the level or select on/off within 5 seconds, or the selected mode will return to previous state. Aligning the source levels (Source Level Adjuster) Volume may vary each time you change the source mode. In this case, you can align each source mode's volume to almost the same level. 1 Press SRC or BAND repeatedly to select the desired mode. 2 Press DISP while pressing SEL. "LA 0" appears in the display. 3 Turn AUDIO CONTROL to adjust the level. Note Adjust the level within 5 seconds, or the selected mode will be canceled. Restoring the factory settings 1 Turn off the unit. 2 Press and hold DISP until "LA --" appears in the display. Note You can restore the factory settings only for VOL, BASS, TRE, BAL, FAD, and H-BASS, and aligned source volume levels. Muting button beep sounds 1 Turn off the unit. 2 Press and hold SEL until "bEEP" appears in the display. 3 Turn AUDIO CONTROL to select on (level indicators appear) or off (level indicators disappear). 4 Press SEL. ENGLISH ENGLISH 2