ASRock A770DE Quick Installation Guide - Page 20
English, 8 Onboard Headers and Connectors
View all ASRock A770DE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
2.8 Onboard Headers and Connectors Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard! • Floppy Connector (33-pin FLOPPY1) (see p.2 No. 26) the red-striped side to Pin1 Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector. Primary IDE connector (Blue) (39-pin IDE1, see p.2 No. 9) connect the blue end to the motherboard connect the black end to the IDE devices 80-conductor ATA 66/100/133 cable Note: Please refer to the instruction of your IDE device vendor for the details. Serial ATAII Connectors (SATAII_1: see p.2, No. 14) (SATAII_2: see p.2, No. 18) (SATAII_3: see p.2, No. 15) (SATAII_4: see p.2, No. 16) (SATAII_5: see p.2, No. 12) (SATAII_6: see p.2, No. 13) SATAII_5 SATAII_6 SATAII_1 SATAII_3 SATAII_2 SATAII_4 These six Serial ATAII (SATAII) connectors support SATAII or SATA hard disk for internal storage devices. The current SATAII interface allows up to 3.0 Gb/s data transfer rate. Serial ATA (SATA) Data Cable (Optional) Either end of the SATA data cable can be connected to the SATA / SATAII hard disk or the SATAII connector on this motherboard. Serial ATA (SATA) Please connect the black end of Power Cable SATA power cable to the power (Optional) connect to the SATA HDD power connector connect to the power supply connector on each drive. Then connect the white end of SATA power cable to the power connector of the power supply. 20 ASRock A770DE+ Motherboard English