ASRock G31M-VS2 Quick Installation Guide - Page 15
English, 6 Onboard Headers and Connectors
View all ASRock G31M-VS2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
2.6 Onboard Headers and Connectors Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard! Primary IDE connector (Blue) (39-pin IDE1, see p.2 No. 8) connect the blue end connect the black end to the motherboard to the IDE devices 80-conductor ATA 66/100 cable Note: Please refer to the instruction of your IDE device vendor for the details. Serial ATAII Connectors These four Serial ATAII (SATAII) (SATAII_1: see p.2, No. 10) (SATAII_2: see p.2, No. 11) (SATAII_3: SATAII_4 SATAII_3 SATAII_2 SATAII_1 connectors support SATAII or SATA hard disk for internal storage devices. The current SATAII interface allows up to 3.0 Gb/s data transfer rate. see p.2, No. 12) (SATAII_4: see p.2, No. 13) Serial ATA (SATA) Data Cable (Optional) Either end of the SATA data cable can be connected to the SATA / SATAII hard disk or the SATAII connector on the motherboard. English 15 ASRock G31M-VS2 Motherboard