ASRock H61M-DP3 Quick Installation Guide - Page 10
English, 5 Onboard Headers and Connectors
View all ASRock H61M-DP3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
1.5 Onboard Headers and Connectors Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard! Serial ATA2 Connectors (SATA_0: see p.2, No. 13) (SATA_1: see p.2, No. 11) (SATA_2: see p.2, No. 14) (SATA_3: see p.2, No. 10) SATA_3 SATA_2 SATA_1 SATA_0 These four Serial ATA2 (SATA2) connectors support SATA data cables for internal storage devices. The current SATA2 interface allows up to 3.0 Gb/s data transfer rate. Serial ATA (SATA) Data Cable (Optional) Either end of the SATA data cable can be connected to the SATA2 hard disk or the SATA2 connector on this motherboard. USB 2.0 Headers (9-pin USB4_5) (see p.2 No. 16) (9-pin USB6_7) (see p.2 No. 15) Besides four default USB 2.0 ports on the I/O panel, there are two USB 2.0 headers on this motherboard. Each USB 2.0 header can support two USB 2.0 ports. English Consumer Infrared Module Header (4-pin CIR1) (see p.2 No. 17) This header can be used to connect the remote controller receiver. 10 ASRock H61M-DP3 Motherboard