ASRock K10N78M Quick Installation Guide - Page 24

2.9 Onboard Headers and Connectors Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent dam- age of the motherboard! • Floppy Connector (33-pin FLOPPY1) (see p.2 No. 22) the red-striped side to Pin1 Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector. Primary IDE connector (Blue) (39-pin IDE1, see p.2 No. 8) connect the blue end to the motherboard connect the black end to the IDE devices 80-conductor ATA 66/100/133 cable Note: Please refer to the instruction of your IDE device vendor for the details. SATAII_3 SATAII_4 (PORT 2) (PORT 3) SATAII_1 SATAII_2 (PORT 0) (PORT 1) Serial ATA II Connectors (SATAII_1 (PORT 0): see p.2, No. 11) (SATAII_2 (PORT 1): see p.2, No. 9) (SATAII_3 (PORT 2): see p.2, No. 12) (SATAII_4 (PORT 3): see p.2, No. 10) These four Serial ATAII (SATAII) connectors support SATA data cables for internal storage devices. The current SATAII interface allows up to 3.0 Gb/s data transfer rate. Serial ATA (SATA) Data Cable (Optional) Serial ATA (SATA) Power Cable (Optional) connect to the SATA HDD power connector connect to the power supply Either end of the SATA data cable can be connected to the SATA / SATAII hard disk or the SATAII connector on this motherboard. Please connect the black end of SATA power cable to the power connector on each drive. Then connect the white end of SATA power cable to the power connector of the power supply. 24 ASRock K10N78M Motherboard English