ASRock K7NF2-RAID RAID Installation Guide - Page 3

1.2 Making a SATA Driver Diskette If you just want to install Windows 2000 or Windows XP on your SATA HDDs without RAID functions, there is no need to make a SATA driver diskette. However, if you want to install Windows 2000 or Windows XP on your SATA HDDs with RAID functions, you will need to make an SATA driver diskette before you start the OS installation. STEP 1: Insert the ASRock Support CD into your optical drive to boot your system. (Do NOT insert any floppy diskette into the floppy drive at this moment!) STEP 2: During POST at the beginning of system boot-up, press key, and then a window for boot devices selection appears. Please select CD-ROM as the boot device. STEP 3: When you see the message on the screen, "Do you want to generate Serial ATA driver diskette [YN]?", press . STEP 4: Then you will see these messages, Please insert a diskette into the floppy drive. WARNING! Formatting the floppy diskette will lose ALL data in it! Start to format and copy files [YN]? Please insert a floppy diskette into the floppy drive, and press . STEP 5: The system will start to format the floppy diskette and copy SATA drivers into the floppy diskette. Once you have the SATA driver diskette ready, you may start to install Windows 2000 / Windows XP on your system directly without setting the RAID configuration on your system, or you may start to use "RAID BIOS Setting Utility" in the section 2.3 to set RAID 0 / RAID 1 / JBOD configuration before you install the OS. You may also set the RAID configuration by using "RAID Utility for Windows" in Windows environment. Please refer to the document in the Support CD, "Guide to RAID Utility for Windows", which is located in the folder at the following path: .. \ RAID Utility for Windows 3