ASRock K7VM3 Quick Installation Guide - Page 10
Connectors, English - ata 133 motherboard
View all ASRock K7VM3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
2.5 Connectors Connectors are NOT jumpers. DO NOT place jumper caps over these connectors. Connector FDD connector (33-pin FLOPPY1) (see p.2 item 19) Figure Description red marking Note: Match the red marking on the floppy ribbon cable with Pin1. Primary IDE connector (Blue) (39-pin IDE1, see p.2 item 10) Secondary IDE connector (Black) (39-pin IDE2, see p.2 item 9) Connector this BLUE end Connect this BLACK end to the motherboard to the IDE devices 80-Pin ATA 100/133 cable Note:To optimize compatibility and performance, please connect your hard disk drive to the primary IDE connector (IDE1, blue) and CD-ROM to the secondary IDE connector (IDE2, black). USB 2.0 header (9-pin USB45) (see p.2 item 20) ASRock I/OTM already provided 4 default USB 2.0 ports. If the 4 USB 2.0 ports on the rear panel are not sufficient, this USB 2.0 header is available to support 2 additional USB 2.0 ports. Infrared module connector (5-pin IR1) (see p.2 item 21) This connector supports an optional wireless transmitting and receiving infrared module. Internal audio connectors (4-pin CD1, 4-pin AUX1) (CD1: see p.2 item 29) (AUX1: see p.2 item 30) AUX1 CD1 These connectors allow you to receive stereo audio input from sound sources such as a CD-ROM, DVD-ROM, TV tuner card, or MPEG card. 10 ASRock K7VM3 Motherboard English