ASRock X79 Extreme11 LSI Mega RAID Storage Manager Guide - Page 19
Installing a SNMP Agent on Windows
View all ASRock X79 Extreme11 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
# svcadm enable svc:/application/management/sma:default Note: Refer to the command man snmpd.conf for more information about configuring the snmpd.conf file. Configuring SNMP Traps To receive SNMP traps, perform the following steps: 1. Stop the LSI SAS SNMP Agent by using the following command: #/etc/init.d/lsi_mrdsnmpd stop 2. Edit the /etc/lsi_mrdsnmp/sas/sas_TrapDestination.conf file and add the IP address as shown in the following excerpt: Agent Service needs the IP addresses to sent trap # The trap destination may be specified in this file # or using snmpd.conf file. Following indicators can # be set on "TrapDestInd" to instruct the agent to # pick the IPs as the destination. # 1 - IPs only from snmpd.conf # 2 - IPs from this file only # 3 - IPs from both the files TrapDestInd 2 Trap Destination IP 127.0.0.1 public 172.28.157.149 public 3. Start the LSI SAS SNMP Agent by entering the following command: #/etc/init.d/lsi_mrdsnmpd start Uninstalling the SNMP Package The uninstall.sh script is located under the /etc/lsi_mrdsnmp/sas directory. Use the following command to uninstall the package: # cd /etc/lsi_mrdsnmp/sas # ./uninstall.sh Installing a SNMP Agent on Windows This section explains how to install and configure the SAS SNMP Agent for the Windows operating system. Installing SNMP Agent Perform the following steps to install the SNMP Agent: 1. Run setup.exe from DISK1. 2. Use the SNMP Manager to retrieve the SAS data (it is assumed that you have compiled LSI- AdapterSAS.mib file already). DB09-000202-05 37857-02 Installation Rev. F - May 2011 Copyright © 2011 by LSI Corporation. All rights reserved. Page 19