ATI V3300 User Guide - Page 37

Setting the ATI HDTV Component Video Adapter DIP Switches 31 Setting the ATI HDTV Component Video Adapter DIP Switches Configure the DIP switches to set the appropriate display mode and aspect ratio. This sets the modes which appear when you select Show all Modes in the ATI Control Panel as described in See "Using Your ATI HDTV Component Video Adapter". Display Modes • DIP switch 3 is always OFF (540p is not supported) L • Set all DIP switches ON that correspond to the modes that your component input device supports; for further details, consult the manual for your component video input device. The six DIP switches on the ATI HDTV Component Video Adapter enable four, standard HDTV video modes: 480i, 480p, 720p,and 1080i. The default setting is 480i or 480p, depending upon your component input device. In the example below, 480i, 480p, and 1080i are supported. Use a small, flat-head screwdriver to set the switches - the up position is ON, and the down position if OFF. Set the switches ON for all modes that your HDTV or component input device supports. Aspect Ratio If your display supports 16:9 aspect ratio, set DIP switch 6 (16:9) ON. This switch toggles between 4:3 and 16:9 - OFF is 4:3.