Aastra 7106a User guide Aastra 7106a for MX-ONE - Page 27

System Dependent Phone Setting Message Waiting Memory (MWM) There is a message waiting memory in the telephone where the number to the voicemail box shall be stored. Save MWM 1. Place the handset on the phone and press 2. Press and enter the number to be saved 3. Press key again to complete saving Dial from a MWM 1. Pick up the handset or press 'Speaker/Handset' 2. Press the Message Waiting LED When there is a message, the message waiting LED will be lighted ON or flashing in blue. The Message Waiting switch (at the back of the phone) is used to select the appropriate MW mode (HV / + / -). Please check which MW type the PBX system supports. Select "OFF" on the MW switch to deactivate the message waiting function. If the LED is steady active, change the message waiting switch position. Set Flash time Some systems require a different flash time for the flash key. To change the flash time, proceed as follows: 1. Press # 0 1 # X # where X is the flash time value between 1 and 9. See table below Parameters Set flash time Programming key sequence [save]+[#]+[0]+ [1]+[#]+[X]+[#] Lock Protected Yes Valid Settings 1: 100ms 2: 200ms 3: 300ms 4: 400ms 6: 600ms 9: 900ms Default 100ms 27