Aastra 7187a Aastra 7187a for MX-ONE - Page 33

System Dependent Phone setting

Get Aastra 7187a PDF manuals and user guides View all Aastra 7187a manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

System Dependent Phone setting Message Waiting Memory (MWM) The message waiting memory normally stores the number to reach the voicemail box. Save MWM 1. Place the handset on the phone and press 2. Press and enter the number to be saved 3. Press key again to complete saving Dial from a MWM 1. Pick up the handset or press 'Speaker/Handset' 2. Press the Delete MWM 1. Place the handset on the phone 2. Press 3. Press Message Waiting LED When there is a message, the message waiting LED will be lighted ON or flashing in blue. When there's message waiting to be read, the message waiting LED will be lighted ON or flashing in red. The Message Waiting switch (at the back of the phone) is used to select the appropriate MW mode (HV / + / -). Please check the MW type of the connected PBX to work with the phone. Select "OFF" on the MW switch to deactivate the message waiting function. If the LED is steady active, change the message waiting switch position. 33

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
33
System Dependent Phone setting
Message Waiting Memory (MWM
)
The message waiting memory normally stores the number to reach the voicemail box
.
Save MWM
1.
Place the handset on the phone and press
2.
Press
and enter the number to be saved
3.
Press
key again to complete saving
Dial from a MWM
1.
Pick up the handset or press ‘Speaker/Handset’
2.
Press the
Delete MWM
1.
Place the handset on the phone
2.
Press
3.
Press
Message Waiting LED
When there is a message, the message waiting LED will be lighted ON or flashing in
blue.
When there’s message waiting to be read, the message waiting LED will be lighted ON
or flashing in red.
The Message Waiting switch (at the back of the phone) is used to select the
appropriate MW mode (HV / + / -). Please check the MW type of the connected PBX to
work with the phone. Select “OFF” on the MW switch to deactivate the message
waiting function.
If the LED is steady active, change the message waiting switch position.