Aastra RFP 32 Datasheet RFP 32 IP and RFP 34 IP - Page 2

Features DECT  All 120 (in America 60) DECT channels supported for maximum use of DECT capacity  8 simultaneous voice channels per RFP, 4 additional channels for handover  GAP standard supported  Connection handover in line with the GAP standard  DSAA authentication between base and handset  Support of DECT encryption  Cordless system telephones can use all features offered by the OpenCom 100, 1000 and SIP-DECT  Integrated DECT antenna in RFP (L)32 IP  External dipole or directional antenna on the RFP (L)34 IP Service and Installation  3 LEDs signalling the current opera- ting state: on RFP (L)32 IP outside, on RFP (L)34 IP inside  Central configuration  Central system journal  Central cluster administration  Wiring alternatively from below (cable duct) or from above (suspended ceiling) for RFP (L)32 IP  RFP (L)34 IP can be connected via RJ 45 or IDC (insulation displacement contact) connectors Ethernet  Connection via Ethernet 100 BaseT  Power supply in line with Power over Ethernet standard IEEE 802.3af, class 0  IPv4 VoIP  VoIP connection using RTP / RTCP protocol  G.711 / G.723.1 / G.729AB1 codec depending on required voice quality and available bandwidth  Quality of service supported by Diffserv/ToS Flag  Adaptive jitter compensation  Echo cancellation / suppression  Voice activity detection and comfort noise generator Requirements  DHCP  TFTP RFP (L)32 IP (Indoor)  Power supply: • Power over Ethernet IEEE 802.3af, class 0 or • 230 V AC adapter  Ambient temperature: -5°C to +45°C  Relative humidity: 5 to 95% (non-condensing)  Storage temperature: -40°C to +70°C  Current consumption: 120mA  Type of ingress protection: IP 20  Flame resistance UL94 V0-5VB  Wall-mountable  Colour: ice grey  Weight: 417 g (without AC adapter)  Dimensions (W x H x D): 195 x 200 x 30 mm RFP (L)34 IP (Outdoor)  Power supply: Power over Ethernet IEEE 802.3af, class 0  Ambient temperature: -25°C to +55°C  Relative humidity: 5 to 95% (non-condensing)  Storage temperature: -5°C to +45°C  Current consumption: 120mA  Type of ingress protection: IP 65  Flame resistance UL94 V0  Wall- and mast-mountable  Colour: light grey  Weight: 1.006 g  Dimensions (W x H x D): 240 x 243 x 60 mm Part numbers RFP (L)32 IP  RFP 32 IP (just for EMEA and Australia) 69207  RFP L32 IP (just for EMEA and Australia) 68883  RFP 32 (just for America) D0069-135D-00-00  AC adapter for EMEA, NA, UK and Australia 68744 Part numbers RFP (L)34 IP  RFP 34 IP (without antennas and just for EMEA and Australia) 69205  RFP L34 IP (without antennas and just for EMEA and Australia) 68882  RFP 34 (with dipole antennas, just for America) D0069-134-00-00  Dipole antennas 4602421  Directional antenna 4602422  Wall-mounting set 4602286  Mast-mounting device Ø 65 mm 4602437  Mast-mounting device Ø > 65 mm 4602285  Antenna-mounting device 71061801  Antenna cable 0,5m 4604685 (1) Additional licence required Reference 09/2011 Aastra Technologies Limited 155 Snow Blvd. Concord, Ontario Canada L4K 4N9 www.aastra.com Copyright © 2011 Aastra Technologies Limited. Aastra and the Aastra logo are trademarks or registered trademarks of Aastra Technologies Limited in the United States, Canada, European Union and other countries. Picture similar to product. The right for technical modifications is reserved.