Aastra RFP L43 Datasheet RFP (L)43 WLAN - Page 2

Features WLAN Access Point Technical Data DECT All 120 DECT channels supported for maximum use of the DECT capacity 8 simultaneous voice channels per DECToverIP base station, 4 additional channels for handover Synchronisation of the RFPs via DECT radio interface GAP standard supported (incl. connection handover) DSAA authentication between base and handset Support of • IEEE 802.11n (2.4 or 5 GHz, MIMO 2T/2R) • IEEE 802.11a • IEEE 802.11b/g Adjustable transmission power level for easy network planning Central service interface for all WLAN Access Points 802.11d Multiple Regulatory Domains, enabling country specific WLAN channel selection Internal antennas for DECT, 2.4 GHz WLAN and 5 GHz WLAN Power supply: • Power over Ethernet IEEE 802.3af, class 3 or • 230 V AC-adapter USB 2.0 host port for future extensions Ambient temperature: -5°C to +45°C Relative humidity: 0 % to 95% (noncondensing) Storage temperature: -40°C to +70°C Support of DECT encryption Cordless system telephones can use all system features offered by OpenCom 100, 1000 and SIP-DECT Wireless Multimedia Extensions (WME) for quality of service Security Features Type of ingress protection: IP 20  Flame resistance UL94 V0-5VB  Wall-mountable Antenna diversity DECT XQ to guarantee good speech quality in reflecting environments VoIP VoIP connection using RTP/RTCP protocol G.711 / G.722 / G.729AB1 codec depending on required voice quality and available bandwidth Quality of service supported by Diffserv / ToS Flag Adaptive jitter compensation Echo cancellation / suppression Voice activity detection and comfort noise generator  Wired Equivalent Privacy (WEP), set able for 64-, 128- and 256-bit encryption WPA1 (Wi-Fi Protected Access) encryption WAP2 with asymmetric encryption Authentication of stations with RADIUS 802.1x server White list for allowed WLAN stations for up to 64 MAC address entries 64-entry associated stations list Hidden Service Set Identifier (SSID) Multiple BSSID (Basic Service Set Identifier) enables four parallel WLAN networks within one access point infrastructure Colour: ice grey  Weight: 467 g (without AC adapter) Dimensions (W x H x D): 195 x 200 x 30 mm (without antenna) Minimum Software Requirements OpenCom 100: ≥ Release 10 OpenCom 1000: ≥ Release 6.1 SIP-DECT: ≥ Release 3.0 Part Numbers RFP 43 WLAN RFP L43 WLAN 68636 68620 Ethernet Service and Installation BaseT connection via Ethernet 10 / 100 / 4 LEDs signalling the current state of 1000 Mbit operation AC adapter for EMEA, UK, Australia and NA AC adapter for EMEA, UK, Australia 87-00002AAA-A 68744 Optional SNMPv1/v2c, MIB II, read only, support of traps  Support of VLANs (virtual LANs) Central configuration Central system journal Central cluster administration  Wiring alternatively from below (cable duct) or from above (suspended ceiling) (1) Additional licence required Reference 05/2013 Aastra Technologies Limited 155 Snow Blvd. Concord, Ontario Canada L4K 4N9 www.aastra.com Copyright © 2013 Aastra Technologies Limited. Aastra and the Aastra logo are trademarks or registered trademarks of Aastra Technologies Limited in the United States, Canada, European Union and other countries. SIP-DECT is a registered trademark of Aastra Deutschland GmbH. Picture similar to product. The right for technical modifications is reserved.