Acer Aspire 1400 Aspire 1400 Notebook Service Guide - Page 80

Index of Error Messages, Error Code List, Error Message List - cmos battery

Page 80 highlights

Index of Error Messages Error Code List Error Codes 006 010 070 071 072 080 110 Error Message List Error Messages Equipment Configuration Error Equipment Configuration Error Real Time Clock Error 1 CMOS Battery Bad 4 CMOS Checksum Error 1 Battery Is Critical Low 1 Incorrect password specified, system halted 1 Error Messages 0200 Failure Fixed Disk 0211 Keyboard error 0212 Keyboard Controller Failed 0213Keyboard locked - Unlock key switch 0220 Monitor type does not match CMOS - Run SETUP 0230 Shadow RAM Failed at offset: nnnn 0231 System RAM Failed at offset: nnnn 0232 Extended RAM Failed at offset: nnnn 0250 System battery is dead - Replace and run SETUP 0251 System CMOS checksum bad - Default configuration used 0260 System timer error 0270 Real time clock error 0280 Previous boot incomplete - Default configuration used 0281 Memory size found by POST differed from CMOS FRU/Action in Sequence Hard disk error detected. Check to see if fixed disk is attached properly. Enter the BIOS Setup Utility and verify the hard disk is detected. see "Keyboard or Auxiliary Input Device Check" on page 71. see "Keyboard or Auxiliary Input Device Check" on page 71. May require replacing the keyboard controller. Unlock the system to proceed. Display device mismatch. Enter the BIOS Setup Utility and verify the parameters (try loading the default settings); then save and restart the computer. Shadow RAM test failed Main board System RAM test failed Main board Extended RAM test failed Main board CMOS clock battery needs to be replaced. Replace the battery and run BIOS Setup Utility to reconfigure system time, then reboot system. CMOS has been corrupted or modified incorrectly. Run BIOS Setup Utility and verify the parameters; then save and restart the computer. Check the system battery. System timer test fiailed, and the main board needs to be repaired. Run BIOS Setup Utility to reconfigure system time, then reboot system. Main board RTC battery Run BIOS Setup Utility to reconfigure system time, then reboot system. Main board Previous boot-up was not copleted successfully. Enter the BIOS Setup Utility and verify the parameters (try loading the default settings); then save and restart the computer. RTC battery Main board Run "Load Setup Defaults" in BIOS Setup Utility. Main board 74 Chapter 4

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.