Acer Aspire 4732Z Acer Aspire 4332, Aspire 4732Z Series Service Guide - Page 65

Troubleshooting Chapter 4 This chapter list the POST error indicators and BIOS beep codes, as well general troubleshooting instructions. POST Error Indicators When a system error is detected during POST (Power On Self Text), the Setup Utility will switch to diagnostic mode and will either: • Displays a POST error message, or • Emits a series of beep codes POST Error Messages POST error messages tell users what failure the system has detected. Some error messages could be related to a hardware device. Others may indicate a problem with a device configuration. In some cases an error message may include recommendations for troubleshooting or require that you press the Enter key to display recommendations. Follow the instructions on the screen. It is recommended that you correct the error before proceeding, even if the computer appears to boot successfully. The table below lists the messages that the BIOS has defined and can display. If your system displays one of the messages marked below with an asterisk (*), write down the code and message and contact your Acer service provider. IMPORTANT: If your system fails after you make changes in the Setup menus, reboot the computer, enter Setup again and load Setup defaults to correct the error. Error Messages Stuck Key System CMOS checksum bad - Default configuration used Real time clock error Previous boot incomplete - Default configuration used Invalid System Configuration Data Operating system not found Check or do the following in sequence: See "Keyboard or Auxiliary Input Device Check" section on page 63. • RTC battery • Run the BIOS Setup Utility to reconfigure the system time, then reboot system. • RTC battery • Run the BIOS Setup Utility to reconfigure system time, then reboot system. • Mainboard • Select "Load Setup Defaults" in the BIOS Setup Utility's Exit menu. • RTC battery • Mainboard • Select "Load Setup Defaults" in the BIOS Setup Utility's Exit menu. • Mainboard • Run the BIOS Setup Utility to check if the fixed disk and drive A are properly identified. • Optical disc drive • Hard disk drive • Mainboard Acer Aspire 4732Z/4332 Service Guide 57