Acer C200 User Manual - Page 3

• OSD function list (By Icon) (By selection) Display Mode: Choose your preferred mode from Bright, Standard or Eco. English Display Keystone Volume Information Language Setting Brightness: Adjust the brightness of the image. Contrast: Adjust the contrast of the image. Projection Mode: Choose Front or Rear. Aspect Ratio: Choose your desired aspect ratio. Adjust image distortion caused by tilting projection. Adjust the headphone volume. Display the projector information for this projector. Select your preferred menu language. Reset: Choose "Yes" to return the parameters on all menus to the factory default settings. Note 1: Functions vary depending on model definition. Note 2: Does not guarantee the USB speaker sound quality. Information for your safety and comfort Read these instructions carefully. Keep this document for future reference. Follow all warnings and instructions marked on the product. Using electrical power This product should be operated from the type of power indicated on the marking label. If you are not sure of the type of power available, consult your dealer or local power company. Product servicing Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage points or other risks. Refer all servicing to qualified service personnel. Additional safety information • Do not look into the projector's lens when the light is on. The bright may hurt your eyes. • Do not place the product in following environments: ■ Locations where excessive humidity, dust, or cigarette smoke may contaminate optical components, shortening the life span and darkening the image. ■ Locations with an ambient temperature above 40 ºC/104 ºF. • Unplug immediately if there is something wrong with your projector. Do not operate if smoke, strange noise or odor comes out of your projector. It might cause fire or electric shock. In this case, unplug immediately and contact your dealer. • Do not face the projector lens to the sun. It can lead to fire. • Do not look into the air outlet grille when projector is operating. It may hurt your eyes. Disposal instructions Do not throw this electronic device into the trash when discarding. To minimize pollution and ensure utmost protection of the global environment, please recycle. For more information on the Waste from Electrical and Electronics Equipment (WEEE) regulations, visit http://www.acer-group. com/public/Sustainability/ sustainability01.htm Use projector in a sideway or ceiling mode is not supported. Regulations and safety notices FCC notice This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the device and receiver. • Connect the device into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/television technician for help. Notice: Shielded cables All connections to other computing devices must be made using shielded cables to maintain compliance with FCC regulations. Notice: Peripheral devices Only peripherals (input/output devices, terminals, printers, etc.) certified to comply with the Class B limits may be attached to this equipment. Operation with non-certified peripherals is likely to result in interference to radio and TV reception. Caution Changes or modifications not expressly approved by the manufacturer could void the user's authority, which is granted by the Federal Communications Commission, to operate this device. Operation conditions This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Notice: Canadian users This Class B digital apparatus complies with Canadian ICES-003. Remarque à l'intention des utilisateurs canadiens Cet appareil numérique de la classe B est conforme a la norme NMB003 du Canada. CE declaration of conformity We hereby declare above product is in compliance with the essential requirements and other relevant provisions of EMC Directive 2014/30/ EU, Low Voltage Directive 2014/35/EU and RoHS Directive 2011/65/EU and Directive 2009/125/EC with regard to establishing a framework for the setting of ecodesign requirements for energy-related product.