Acer Ferrari 5000 Ferrari 5000 Service Guide - Page 90

Power-On Self-Test (POST) Error Message, Index of Error Messages - cmos battery

Page 90 highlights

Power-On Self-Test (POST) Error Message The POST error message index lists the error message and their possible causes. NOTE: Perform the FRU replacement or actions in the sequence shown in Error Message List, if the FRU replacement does not solve the problem, put the original part back in the computer. Do not replace a non-defective FRU. The error messages are listed in the coming pages to indicate the BIOS signals on the screen and the error symptoms classified by functions. If the symptom is not included on the list, please refer to Undetermined Problems. NOTE: Most of the error messages occur during POST. Some of them show information about a hardware device, for example, the size of memory installed. Others may indicate problems with a device, such as the way it has been configured. NOTE: If the system fails after you make changes in the BIOS Setup Utility menus, please reset the computer. Enter Setup and install Setup defaults to correct the errors. Index of Error Messages Error Code List Error Code Error Message 006 Equipment Configuration Error Causes: • CPU BIOS Update Code Mismatch • IDE Primary Channel Master Drive Error The causes will be shown before Equipment Configuration Error. 010 Memory Error at xxxx:xxxx:xxxxh (R: xxxxh, W: xxxxh) 070 Real Time Clock Error 071 CMOS Battery Bad 072 CMOS Checksum Error 110 System disabled. Incorrect password is specified. No error code Battery critical low: In this situation BIOS will issue four short beeps then shut down system, no message will be shown. No error code Thermal critical high: In this situation BIOS will shut down the system, no message will be shown. Error Message List Error Message Failure Fixed Disk Stuck Key Keyboard error Keyboard Controller Failed Keyboard locked - Unlock key switch Monitor type does not match CMOS - Run Setup Shadow RAM Failed at offset: nnnn FRU/Action in Sequence Reconnect hard disk drive connector. Run Load Default Settings in BIOS Setup Utility. Hard disk drive System board see Keyboard or Auxiliary Input Device Check. see Keyboard or Auxiliary Input Device Check. see Keyboard or Auxiliary Input Device Check. Unlock external keyboard Run Load Default Settings in BIOS Setup Utility. BIOS ROM System board Chapter 4 81

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.