Acer TravelMate 8210 TravelMate 8210 Service Guide - Page 85

Power-On Self-Test (POST) Error Message, Index of Error Messages - bios update

Page 85 highlights

Power-On Self-Test (POST) Error Message The POST error message index lists the error message and their possible causes. Note: Perform the FRU replacement or actions in the sequence shown in Error Message List, if the FRU replacement does not solve the problem, put the original part back in the computer. Do not replace a nondefective FRU. The error messages are listed in the coming pages to indicate the BIOS signals on the screen and the error symptoms classified by functions. If the symptom is not included on the list, please refer to "Undetermined Problems". Note: Most of the error messages occur during POST. Some of them show information about a hardware device, for example, the size of memory installed. Others may indicate problems with a device, such as the way it has been configured. Note: If the system fails after you make changes in the BIOS Setup Utility menus, please reset the computer. Enter Setup and install Setup defaults to correct the errors. Index of Error Messages Error Code 006 010 070 071 072 110 No error code No error code Error Message Equipment Configuration Error Causes: 1. CPU BIOS Update Code Mismatch 2. IDE Primary Channel Master Drive Error The causes will be shown before "Equipment Configuration Error". Memory Error at xxxx:xxxx:xxxxh (R: xxxxh, W: xxxxh) Real Time Clock Error CMOS Battery Bad CMOS Checksum Error System disabled. Incorrect password is specified. Battery critical low: In this situation BIOS will issue four short beeps then shut down system, no message will be shown. Thermal critical high: In this situation BIOS will shut down the system, no message will be shown. Error Message Failure Fixed Disk Stuck Key Keyboard error Keyboard Controller Failed Keyboard locked - Unlock key switch Monitor type does not match CMOS - Run Setup Shadow RAM Failed at offset: nnnn FRU/Action in Sequence Reconnect hard disk drive connector. Run "Load Default Settings" in BIOS Setup Utility. Hard disk drive System board see "Keyboard or Auxiliary Input Device Check". see "Keyboard or Auxiliary Input Device Check". see "Keyboard or Auxiliary Input Device Check". Unlock external keyboard Run "Load Default Settings" in BIOS Setup Utility. BIOS ROM System board Chapter 4 75

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.