Home » Acer Manuals » Desktops » Acer Veriton M4610G » Manual Viewer

Acer Veriton M4610G Acer Veriton M4610, M4610G, M4618G Desktop Service Guide - Page 105

Signal Name, Signal, Function, ATX_ POWER: ATX 24-pin Power Connector

View all Acer Veriton M4610G manuals

Add to My Manuals
Save this manual to your list of manuals

Page 105 highlights

ATX_ POWER: ATX 24-pin Power Connector Pin Signal Name 1 +3.3V 2 +3.3V 3 COM 4 +5V 5 COM 6 +5V 7 COM 8 PWR OK 9 +5VSB 10 +12V 11 +12V 12 +3.3V Pin Signal Name 13 +3.3V 14 -12V 15 COM 16 PS_ON 17 COM 18 COM 19 COM 20 -5V 21 +5V 22 +5V 23 +5V 24 COM ATX12V: ATX 12V Power Connector Pin Signal Name 1 Ground 2 Ground 3 +12V 4 +12V Front Panel Header The front panel header (F_PANEL) provides a standard set of switch and LEDheaders commonly found on ATX or micro-ATX cases. Refer to the table below forinformation: Pin Signal Function 1 VCC 5V 3 HDD_LED Hard disk LED 5 GND Ground 7 HWRST_L Reset 9 F_PANEL_DET FRONT PANEL DETECT 11 NC Reserved 13 NC Reserved Pin Signal 2 GLED0 4 GLED1 6 PWRSW 8 GND 10 KEY Function MSG LED MSG LED POWER SWITCh Ground NO PIN 12 VCC 5V 14 F_PANEL_LED FRONT PANEL LED 97 Chapter 5

Section	Page
Veriton M4610/M4610G/M4618G Service Guide	1
Revision History	2
Copyright	3
Disclaimer	4
Conventions	5
Table of Contents	7
System Tour	9
Features	9
Block Diagram	14
System Components	15
Front Panel	15
Rear Panel	16
Hardware Specifications and Configurations	17
Power Management Function(ACPI support function)	20
System Utilities	21
CMOS Setup Utility	21
Entering CMOS setup	22
Navigating Through the Setup Utility	22
System Disassembly and Assembly	33
Disassembly Requirements	33
Pre-disassembly Procedure	34
Removing the Side Panel	35
Removing the Front Bezel	36
Removing the Heat Sink Fan Assembly	37
Removing the Processor	39
Removing the VGA Card	41
Removing the Memory Modules	42
Removing the Hard Disk Drive	43
Removing the Optical Drive	45
Removing the Printer Port Cable and COM Port Cable	47
Removing the Intrusion Alarm and OBR Cable Cable Assembly	49
Removing Other Side Pannel	53
Removing the Power Supply	54
Removing the Card Reader	56
Removing the Internal Speaker	57
Removing the Mainboard	58
Removing the Front I/O and USB Assembly	60
Removing the Power Switch and LED Cable Assembly	62
Assembly Requirements	63
Assembly Procedure	64
Install the Processor	65
Install the Memory	66
Install the Heat Sink Fan Assembly	67
Removing the both Side Panel	68
Install the I/O Shielding	69
Install the Main Board	70
Install the System FAN	72
Install the Optica Drive	74
Install the 3.5’’ Card	76
Install the the COM Port Cable and Printer Port Cable	79
Install the Hard Disk Drive	81
Install the Right Side Panel	84
Install the VGA Card	85
Install the Front Bezel	87
Install the Lift Side Panel	88
System Troubleshooting	89
Hardware Diagnostic Procedure	89
System Check Procedures	90
Power System Check	90
System External Inspection	90
System Internal Inspection	90
Beep Codes	91
Checkpoints	92
Viewing BIOS checkpoints	92
Bootblock Initialization Code Checkpoints	92
Bootblock Recovery Code Checkpoints	94
BIOS Recovery	95
Jumper and Connector Information	96
M/B Placement	96
Jumper Setting	98
Setting Jumper	98
FRU (Field Replaceable Unit) List	106
Veriton M4610/M4610G/M4618G Exploded Diagram	107

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.