Home » Acer Manuals » Desktops » Acer Veriton M4610G » Manual Viewer

Acer Veriton M4610G Acer Veriton M4610, M4610G, M4618G Desktop Service Guide - Page 65

Install the Processor, oriented over the socket.

View all Acer Veriton M4610G manuals

Add to My Manuals
Save this manual to your list of manuals

Page 65 highlights

Install the Processor 1. Release the load lever. 2. Lift the load lever and load plate to the fully open,then take out the CPU cover. 3. Put the CPU in the seat and close the load plate and load lever. NOTE: When you install the processor, note the arrow on the corner to make sure the processor is properly oriented over the socket. Chapter 3 57

Section	Page
Veriton M4610/M4610G/M4618G Service Guide	1
Revision History	2
Copyright	3
Disclaimer	4
Conventions	5
Table of Contents	7
System Tour	9
Features	9
Block Diagram	14
System Components	15
Front Panel	15
Rear Panel	16
Hardware Specifications and Configurations	17
Power Management Function(ACPI support function)	20
System Utilities	21
CMOS Setup Utility	21
Entering CMOS setup	22
Navigating Through the Setup Utility	22
System Disassembly and Assembly	33
Disassembly Requirements	33
Pre-disassembly Procedure	34
Removing the Side Panel	35
Removing the Front Bezel	36
Removing the Heat Sink Fan Assembly	37
Removing the Processor	39
Removing the VGA Card	41
Removing the Memory Modules	42
Removing the Hard Disk Drive	43
Removing the Optical Drive	45
Removing the Printer Port Cable and COM Port Cable	47
Removing the Intrusion Alarm and OBR Cable Cable Assembly	49
Removing Other Side Pannel	53
Removing the Power Supply	54
Removing the Card Reader	56
Removing the Internal Speaker	57
Removing the Mainboard	58
Removing the Front I/O and USB Assembly	60
Removing the Power Switch and LED Cable Assembly	62
Assembly Requirements	63
Assembly Procedure	64
Install the Processor	65
Install the Memory	66
Install the Heat Sink Fan Assembly	67
Removing the both Side Panel	68
Install the I/O Shielding	69
Install the Main Board	70
Install the System FAN	72
Install the Optica Drive	74
Install the 3.5’’ Card	76
Install the the COM Port Cable and Printer Port Cable	79
Install the Hard Disk Drive	81
Install the Right Side Panel	84
Install the VGA Card	85
Install the Front Bezel	87
Install the Lift Side Panel	88
System Troubleshooting	89
Hardware Diagnostic Procedure	89
System Check Procedures	90
Power System Check	90
System External Inspection	90
System Internal Inspection	90
Beep Codes	91
Checkpoints	92
Viewing BIOS checkpoints	92
Bootblock Initialization Code Checkpoints	92
Bootblock Recovery Code Checkpoints	94
BIOS Recovery	95
Jumper and Connector Information	96
M/B Placement	96
Jumper Setting	98
Setting Jumper	98
FRU (Field Replaceable Unit) List	106
Veriton M4610/M4610G/M4618G Exploded Diagram	107

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.