Home » Acer Manuals » Desktops » Acer Veriton X2110 » Manual Viewer

Acer Veriton X2110 Acer Veriton X2110 Desktop Service Guide - Page 59

Removing the Front I/O and Card Reader Boards

Add to My Manuals
Save this manual to your list of manuals

Page 59 highlights

Removing the Front I/O and Card Reader Boards 1. Removing the screw from chassis. 2. Pull the front I/O and USB assembly from chassis. 3. Remove the card reader board. a. Remove the two screws that secure the card reader board to the bracket. 51 Chapter 3

Section	Page
Veriton X2110/X2110G Service Guide	1
Revision History	2
Copyright	3
Disclaimer	4
Conventions	5
Table of Contents	7
System Tour	9
Features	9
Block Diagram	13
System Components	14
Front Panel	14
Rear Panel	15
Hardware Specifications and Configurations	16
Power Management Function(ACPI support function)	19
System Utilities	20
CMOS Setup Utility	20
Entering CMOS setup	21
Navigating Through the Setup Utility	21
Setup Utility Menus	22
System Disassembly and Assembly	36
Disassembly Requirements	36
Pre-disassembly Procedure	37
Removing the Side Panel	38
Removing the Front Bezel	39
Removing the Heat Sink Fan Assembly	40
Removing the Processor	42
Removing the Wireless LAN Card	44
Removing the VGA Card	45
Removing the Memory Modules	46
Removing the Optical Drive	47
Removing the Hard Disk Drive	49
Removing the Power Supply	52
Removing the Mainboard	54
Removing the Power Switch and LED Cable Assembly	57
Removing the Front I/O and Card Reader Boards	59
Assembly Requirements	61
Assembly Procedure	62
Install the Processor	63
Install the Heat Sink Fan Assembly	64
Install the Memory	65
Removing the Side Panel	66
Remove the Front Bezel and the ODD Bracket	68
Install the I/O Shielding	69
Install the Main Board	70
Connect the Cable	71
Install the Optica Drive Bracket	73
Install the Hard Disk Drive	74
Install the Optica Drive	76
Install the VGA Card	78
Install the Wireless LAN Card	79
Install the Front Bezel	80
Install the Side Panel	81
System Troubleshooting	82
Hardware Diagnostic Procedure	82
System Check Procedures	83
Power System Check	83
System External Inspection	83
System Internal Inspection	83
Beep Codes	84
Checkpoints	85
Viewing BIOS checkpoints	85
Bootblock Initialization Code Checkpoints	85
Bootblock Recovery Code Checkpoints	87
BIOS Recovery	88
Jumper and Connector Information	89
M/B Placement	89
Jumper Setting	91
Setting Jumper	91
FRU (Field Replaceable Unit) List	95
Veriton X2110/X2110G Exploded Diagram	96

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.