Adaptec 2093500 User Guide - Page 97
Running the AFU from the Command Line, AFU Commands
View all Adaptec 2093500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Appendix E: Using the Adaptec Flash Utility ● 97 Running the AFU from the Command Line Note: You can also run a menu-based AFU (see page 96). To run the AFU from the command line: 1 Power off your computer, insert the first AFU floppy disk, then power on your computer. If your computer isn't set up to boot from the bootable floppy disk, enter the system setup utility to change the setting. 2 At the DOS command, type AFU followed by a command (see page 97) and any switches you want. Note: To find a controller number, type AFU LIST, then press Enter. The AFU processes the command, prompts you to insert additional floppy disks as needed, exits, and reports either success or an error message code. To update a RAID controller's flash using the command line, see page 100. AFU Commands This section lists the available AFU commands. List Displays the AFU-supported RAID controllers installed on your computer. Also displays the ID numbers assigned to each controller. You don't have to restart the computer after completing this command. This example shows a typical system response to a LIST command: A:\> AFU LIST Adaptec Flash Utility V4.0-0 B5749 (c)Adaptec Inc. 1999-2005. All Rights Reserved. Controllers Detected and Recognized: Controller #0 (03:05:00) Adaptec Adaptec 2230SLP Save Saves the contents of a RAID controller's flash in a UFI file. The name of the UFI file is based on the controller type and can't be changed. You must restart the computer following a SAVE command. The command syntax for the SAVE command is AFU SAVE [/C] [/D ]