Adaptec 3940AUW Installation Guide - Page 4
Default Settings
View all Adaptec 3940AUW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
3 Default Settings AHA-3940AU/AUW host adapters operate correctly with their factory default settings in most computers with PCI slots. The following table lists the settings and their default values. You can change these settings with the SCSISelect utility. (See Configuring the Host Adapter on page 8.) SCSI Bus Interface Definitions Host Adapter SCSI ID SCSI Parity Checking Host Adapter SCSI Termination Boot Device Settings Boot Channel Boot SCSI ID Boot LUN Number1 SCSI Device Configuration Initiate Sync Negotiation Maximum Sync Transfer Rate Enable Disconnection Initiate Wide Negotiation4 Send Start Unit Command5 BIOS Multiple Lun Support 5 Include in BIOS Scan Advanced Configuration Options Plug and Play SCAM Support Reset SCSI Bus at IC Initialization Extended BIOS Translation for DOS Drives > 1 GByte5 Host Adapter BIOS (Configuration Utility Reserves BIOS Space) Support Removable Disks under BIOS as Fixed Disks5 Display Message During BIOS Initialization5 BIOS Support for Bootable CD-ROM5 BIOS Support for Int 13h Extensions5 1. Setting is valid only if Multiple LUN Support is enabled. 2. Default Setting for the AHA-3940AU is 10 MBytes/sec. Default Setting for the AHA-3940AUW is 20 MBytes/sec. 3. Ultra speed for the AHA-3940AU is 20 MBytes/sec. Ultra speed for the AHA-3940AUW is 40 MBytes/sec. 4. AHA-3940AUW only 5. Settings are only valid if channel BIOS is enabled. Default Setting 7 Enabled Automatic Default Setting A First 0 0 Default Setting Yes (Enabled) 10 MBytes/sec2,3 Yes (Enabled) Yes (Enabled) No (Disabled) No (Disabled) Yes (Enabled) Default Setting Disabled Enabled Enabled Enabled Boot Only Enabled Enabled Enabled 3 AHA-3940AU/AUW Installation Guide Part Number: 511418-00, Rev. A Print Spec Number: 496346-00 Current Date: 3/12/97 ECN Date:3/10/97