Adaptec AVA-1505 Installation Guide
Adaptec AVA-1505 - Storage Controller Fast SCSI 10 MBps Manual
 |
View all Adaptec AVA-1505 manuals
Add to My Manuals
Save this manual to your list of manuals |
Adaptec AVA-1505 manual content summary:
- Adaptec AVA-1505 | Installation Guide - Page 1
R AVA-1505 AT-to-SCSI Host Adapter Installation Guide vvvvvvvvvvvv - Adaptec AVA-1505 | Installation Guide - Page 2
1 Getting Started This guide tells you how to install and configure the AVA™-1505 AT®-to-SCSI host adapter. Installation instructions are given in Sections 4 through 8. 2 Board Layout This figure identifies the major AVA-1505 components, and the table describes each component. Location J11 J51 J61 - Adaptec AVA-1505 | Installation Guide - Page 3
s If another Adaptec SCSI host adapter is already installed in your computer, you may need to change the interrupt channel of the AVA-1505. If you devices before you remove the chassis cover. See your computer's documentation for instructions on how to do this. 1 Remove the cover of your computer - Adaptec AVA-1505 | Installation Guide - Page 4
is in the middle of the bus if internal and external SCSI devices are installed. Caution: AVA-1505 host adapters support only single-ended SCSI devices. Differential SCSI devices may be damaged if connected to the host adapter. The peripheral documentation will tell you whether the device is single - Adaptec AVA-1505 | Installation Guide - Page 5
three possible SCSI device and host adapter configurations. Devices Connected to Host Adapter Internal devices only (host adapter at end of bus) External devices only (host adapter at end of bus) Internal and external devices (host adapter in the middle of the bus) AVA-1505 Terminators All three - Adaptec AVA-1505 | Installation Guide - Page 6
ready to use. Booting the Computer The AVA-1505 does not provide booting capability. If you want to boot from a SCSI drive installed on the host adapter, you can install an AVA-1515, which provides booting capability. 6 Software Installation DOS/Windows Platforms For installing software, insert the - Adaptec AVA-1505 | Installation Guide - Page 7
assign each host adapter a unique interrupt channel and port address? If you need replacement components such as a fuse, jumper shunt, or terminator, see your dealer. 8 Jumper Block Settings The AVA-1505 jumper block settings are silkscreened on the board and are used to configure user-selectable - Adaptec AVA-1505 | Installation Guide - Page 8
used in accordance with the instructions, may cause harmful interference to user's authority to operate such equipment. Each AVA-1505 is equipped with an FCC compliance label Adaptec, Inc. All rights reserved. Adaptec and the Adaptec logo are registered trademarks, and AVA is a trademark of Adaptec
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
R
▲▲▲▲▲▲▲▲▲▲▲▲
AVA-1505
AT-to-SCSI Host Adapter
Installation Guide