Airlink WLL013 Manual - Page 25

Status, Wireless Networks, Use Windows to con my wireless, network settings - wireless driver

Get Airlink WLL013 PDF manuals and user guides View all Airlink WLL013 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

Chapter 3 Wireless LAN Monitor Utility 2. On the Wireless Networks tab, uncheck the Use Windows to configure my wireless network settings box and click OK. If you need to revert back to using Windows XP Wireless Zero Configuration Utility, just go to the Wireless Networks tab and check the Use Windows to configure my wireless network settings box and click OK. Status The Status tab displays the current status of your Wireless LAN Card. It also allows you to re-configure the Wireless LAN Card setting. Even though you might have configured the settings during the driver and utility installation, it is possible that you want to change your operating mode between Infrastructure or Ad-Hoc mode and fine-tune other settings. You can connect your computer to a network in one of the following two ways. Refer to sequential sections for configuration: Ad Hoc Infrastructure Connecting to other Wireless LAN Card equipped computers, forming a wireless network. Connecting to a wired/wireless network through an Access Point. 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
Chapter 3
Wireless LAN Monitor Utility
19
2.
On the
Wireless Networks
tab, uncheck the
Use Windows to configure my wireless
network settings
box and click
OK
.
If you need to revert back to using Windows XP
Wireless Zero Configuration
Utility
, just
go to the
Wireless Networks
tab and check the
Use Windows to configure my wireless
network settings
box and click
OK
.
Status
The
Status
tab displays the current status of your Wireless LAN Card. It also allows you to
re-configure the Wireless LAN Card setting. Even though you might have configured the
settings during the driver and utility installation, it is possible that you want to change your
operating mode between Infrastructure or Ad-Hoc mode and fine-tune other settings.
You can connect your computer to a network in one of the following two ways. Refer to
sequential sections for configuration:
Ad Hoc
Connecting to other Wireless LAN Card equipped computers, forming a
wireless network.
Infrastructure
Connecting to a wired/wireless network through an Access Point.