Alpine 9965 Owners Manual - Page 68
Installation
UPC - 793276500526
View all Alpine 9965 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Installation Accessory List • Head unit 1 • Power Supply box 1 • Power cable 1 • S video cable 1 • RCA extension cable (for video signal 1 • Mounting sleeve 1 • Screw (M5 × 8 4 • Flange-head tapping screw (M4 × 14 4 • Velcro Fasteners 2 • Front frame 1 • Remote Control 1 • Battery (CR2025 1 • Carrying case 1 • Owner's Manual 1 set Metal plate Detachable Front panel Caution When you install this unit in your car, do not remove the detachable front panel. If the detachable front panel is removed during installation, you might press too hard and warp the metal plate that holds it in place. 1 Mounting Sleeve (Included) Dashboard Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the DVA-9965. Connect all other leads of the DVA-9965 according to details described in the CONNECTlONS section. 3 Lock Pin Slide the DVA-9965 into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the detachable front panel. Removal 1 Remove the detachable front panel. 2 Use a small screwdriver (or similar tool) to push the locking pins to the "up" position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin. 3 Pull the unit out, keeping it unlocked as you do so. this unit Slide the mounting sleeve into the dashboard. 2 Screw Hex Nut (M5) Front Frame Metal Mounting Strap *2 Bolt Stud *1 Ground Lead Chassis this unit Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (*1) already attached to the vehicle's chassis. • For the screw marked "*2", use an appropriate screw for the chosen mounting location. 66-EN this unit Ground Lead *3 Screws (M5 × 8) (Included) Mounting Bracket • Secure the ground lead of the unit to a clean metal spot using a screw (*3) already attached to the vehicle's chassis.