Alpine CDE-141 Quick Reference Guide - Page 51

Random Play Shuffle (M.I.X.) The Shuffle function of the iPod/iPhone is displayed as s on this unit. Shuffle Albums: The songs on each album are played back in proper order. Upon completion of all the songs on the album, the next album is selected randomly. This continues until all albums have been played. Shuffle Songs: Song shuffle randomly plays back songs within a selected category (playlist, album, etc.). The songs within the category are played just once until all songs have been played. 1 Press 5 x. The songs are played back in random sequence. s*1  s*2  (off )  s *1 Shuffle Albums. *2 Shuffle Songs. 2 To cancel M.I.X. play, select (off) with the above procedure. Note • If a song is selected in the album search mode before selecting M.I.X. play, the songs will not play back randomly even when Shuffle Albums is selected. Shuffle ALL: Shuffle ALL plays all songs in the iPod/iPhone randomly. Any one song does not play back again until all songs have been played back. 1 Press ENTER to activate the search selection mode. 2 Turn the Rotary encoder to select SHUFFLE ALL, and then press ENTER. The "g" indicator lights up. To cancel M.I.X. play, press 5 s to select OFF. Note • If Shuffle ALL is selected, the selected songs being played back in the search mode are canceled. Repeat Play Only Repeat One is available for the iPod/iPhone. Repeat One: A single song is repeatedly played back. 1 Press z 4. The song is played back repeatedly. a*  (off )  a * Repeat One. 2 To cancel repeat play, select (off) with the above procedure. Note • During repeat playback, no other songs are selectable by pressing  or . Information In Case of Difficulty If you encounter a problem, please turn the power off, then on again. If the unit is still not functioning normally, please review the items in the following checklist. This guide will help you isolate the problem if the unit is at fault. Otherwise, make sure the rest of your system is properly connected or consult your authorized Alpine dealer. Basic No function or display. • Vehicle's ignition is off. - If connected following instructions, the unit will not operate with the vehicle's ignition off. • Improper power lead (Red) and battery lead (Yellow) connections. - Check power lead and battery lead connections. • Blown fuse. - Check the fuse of the unit; replace with the proper value if necessary. Radio Unable to receive stations. • No antenna or open connection in cable. - Make sure the antenna is properly connected; replace the antenna or cable if necessary. Unable to tune stations in the seek mode. • You are in a weak signal area. - Make sure the tuner is in the DX mode. • If the area you are in is a primary signal area, the antenna may not be grounded and connected properly. - Check your antenna connections; make sure the antenna is properly grounded at its mounting location. • The antenna may not be the proper length. - Make sure the antenna is fully extended; if broken, replace the antenna with a new one. Broadcast is noisy. • The antenna is not the proper length. - Extend the antenna fully; replace it if it is broken. • The antenna is poorly grounded. - Make sure the antenna is grounded properly at its mounting location. CD CD Player not functioning. • Out of operating temperature range +50°C (+120°F) for CD. - Allow the vehicle's interior (or trunk) temperature to cool. CD playback sound is wavering. • Moisture condensation in the CD Module. - Allow enough time for the condensation to evaporate (about 1 hour). CD insertion not possible. • A CD is already in the CD player. - Eject the CD and remove it. • The CD is being improperly inserted. - Make sure the CD is being inserted following instructions in the CD Player Operation section. 23-EN