Alpine CDE-9841 Owners Manual - Page 13
Sound Setting
View all Alpine CDE-9841 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Sound Setting CDE-9845 SOURCE/ POWER BAND Rotary encoder g BASS C. TREBLE C. f CDE-9843 SOURCE/ POWER BAND Rotary encoder g BASS C. TREBLE C. f CDE-9841 SOURCE/ POWER BAND 4 g CENTER f. MODE f 3 Adjusting Bass/Treble/Balance (Between Left and Right)/Fader (Between Front and Rear)/ Defeat 1 Press the Rotary encoder (CDE-9845/CDE-9843 only) or press MODE (CDE-9841 only) repeatedly to choose the desired mode. Each press changes the modes as follows: BASS → TREBLE → SUBWOOFER* → BALANCE → FADER → DEFEAT → VOLUME → BASS BASS: -7 ~ +10 TREBLE: -7 ~ +7 Subwoofer : 0 ~ +15 Balance : L15 ~ R15 Fader : R15 ~ F15 Defeat : ON/OFF Volume : 0 ~ 35 • If the Rotary encoder is not pressed within 5 seconds after selecting the BASS, TREBLE BALANCE, FADER, DEFEAT or SUBWOOFER mode, the unit automatically returns to normal mode. * When the subwoofer mode is set to OFF, its level cannot be adjusted. 2 Turn the Rotary encoder (CDE-9845/CDE-9843 only) or press 4 and 3 (CDE-9841 only) until the desired sound is obtained in each mode. By setting Defeat ON, previously adjusted settings of BASS and TREBLE will return to the factory defaults and BBE* is turned off. * CDE-9845 only Setting the Bass Control You can change the bass frequency emphasis to create your own tonal preference. 1 Press BASS C. (CDE-9845/CDE-9843 only) or press CENTER f. (CDE-9841 only) to select the Bass (bass center frequency) Control mode. CDE-9845/CDE-9843: BASS ↔ normal CDE-9841: BASS → TREBLE → normal mode → BASS 2-1 Setting the bass center frequency: Press g or f to select the desired bass center frequency. 60Hz ↔ 80Hz ↔ 100Hz ↔ 120Hz ↔ 60Hz The displayed bass frequency is emphasized 2-2 Setting the bass band width (Q-Factor): Press BAND to select the desired bass band width. →1 → 2 → 3 → 4 (Narrow Wide) Changes the boosted bass band width to wide or narrow. A wide setting will boost a wide range of frequencies above and below the center frequency. A narrower setting will boost only frequencies near the center frequency. 2-3 Setting the bass level: Turn the Rotary encoder (CDE-9845/CDE-9843 only) or press 4 and 3 (CDE-9841 only) to select the desired bass level (-7~+10). You can emphasize or weaken the bass frequency. • If no operation is performed within 15 seconds, the bass control setting will be turned off automatically. • The bass level settings will be individually memorized for each source (FM, AM, CD, etc.) until the setting is changed. The bass frequency and bass band width settings adjusted for one source are effective for all other sources (FM, AM, CD etc.). • This function is inoperable when DEFEAT is set to ON. 12-EN