Alpine INE-W970HD Installation Manual - Page 5

Precautions • Be sure to disconnect the cable from the (-) battery post before installing your unit. This will reduce any chance of damage to the unit in case of a short-circuit. • Be sure to connect the color coded leads according to the diagram. Incorrect connections may cause the unit to malfunction or damage to the vehicle's electrical system. • When making connections to the vehicle's electrical system, be aware of the factory installed components (e.g. on-board computer). Do not tap into these leads to provide power for this unit. When connecting the unit to the fuse box, make sure the fuse for the intended circuit of the unit has the appropriate amperage. When in doubt, consult your Alpine dealer. • Be sure to connect the speaker (-) leads to the speaker (-) terminal. Never connect left and right channel speaker cables to each other or to the vehicle body. Accessory List • INE-W970HD 1 • Power cable 1 • SD CARD 1 • GPS Antenna 1 • Antenna mounting plate 1 • Cable clamp for antenna 1set • USB extension cable 2 • PRE OUT cable 1 • Microphone 1 • Interface cable 1 • Mounting sleeve 1 • Face plate 1 • Mounting sleeve release key 2 • Flush Head Screw (M5 8mm 6 • Screw (M5 8mm 8 • Owner's Manual 1set Installation Caution concerning the installation location Angle of installation Install at an angle between horizontal and 30°. Note that installing at an angle outside of this range will result in a loss of performance and possibly damage. 0 - 30° Mounting the GPS Antenna inside the vehicle 1 Clean the mounting location. 2 Put on the GPS Antenna mounting plate. 3 Mount the GPS Antenna. GPS Antenna Antenna mounting plate This unit Caution Do not block the unit's fan, thus preventing air circulation. If blocked, heat will accumulate inside the unit and may cause a fire. Rear of the Unit Air ventilation hole • Do not mount the GPS Antenna inside the center console. - Mount the GPS Antenna on a flat plane of the dash board or rear tray. - Make sure the GPS Antenna is not covered (obstructed) by any metallic surface or object. • If the GPS Antenna is mounted near the unit, the reception becomes poor, and the location of your vehicle may not be displayed correctly. - Mount the GPS Antenna far away enough from the unit. - Bundle the GPS Antenna cable away from the rear of the unit. • Some thermal reflection type or thermal absorption type glass may interrupt high frequency waves. If reception is poor with the antenna installed inside the car, try to mount the antenna outside the car. 3 -EN ALPINE_Install_Manual_AM_ENG_191019.indd 3 2019-10-19 오후 7:22:28