Alpine IVA W205 Owners Manual - Page 68
Indication for CD/MP3/WMA - cd problems
UPC - 093276200588
View all Alpine IVA W205 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Error displays. • Mechanical error. - Touch [ ] of DISC on the EJECT/TILT screen. After the error indication disappears, insert the disc again. If the abovementioned solution does not solve the problem, consult your nearest Alpine dealer. MP3/WMA is not played back. • Writing error occurred. The CD format is not compatible. - Make sure the CD has been written in a supported format. Refer to "About MP3/WMA" (pages 16 and 17), then rewrite in the format supported by this device. Unit does not operate. • Monitor's power is not turned on. - Turn on the monitor's power. • Condensation. - Wait a while (about 1 hour) for the condensation to dry. No picture is produced. • Monitor's mode is not switched to the mode you want to see. - Switch to the mode you want to see. • Monitor's parking brake lead is not connected. - Connect the monitor's parking brake wire and set the parking brake. (For details, refer to the monitor's instructions.) Playback does not start. • Disc is loaded upside-down. - Check the disc and load it with the labeled side facing upward. • Disc is dirty. - Clean the disc. • A disc not able to play back with this unit is loaded. - Check if the disc is able to be played back. • Parental lock is set. - Cancel the parental lock or change the rating level. Picture is unclear or noisy. • Disc is being fast-forwarded or fast-reversed. - The picture may be slightly disturbed, but this is normal. • Vehicle's battery power is weak. - Check the battery power and wiring. (The unit may malfunction if the battery power is under 11 volts with a load applied.) • Monitor's fluorescent tube is worn. - Replace the monitor's fluorescent tube. Image stops sometimes. • Disc is scratched. - Replaced with a non-scratched disc. Indication for CD/MP3/WMA • Protective circuit is activated due to high temperature. - The indicator will disappear when the temperature returns to within operation range. - Leave the power OFF until the temperature decreases and then turn the power ON again. • No disc is inserted. - Insert a disc. • Although a disc is inserted, "NO DISC" is displayed and the unit does not start to play or eject the disc. - Remove the disc by following these steps. Press for at least 3 seconds. • Mechanism error. 1) Touch [ ] of DISC on the EJECT/TILT screen and eject the disc. If not ejecting, consult your Alpine dealer. 2) When the error indication remains after ejecting, touch [ ] of DISC on the EJECT/TILT screen again. If the error indication still does not turn off after trying to touch [ ] of DISC on the EJECT/TILT screen. for a few times, consult your Alpine dealer. • Disc was forcibly pulled out by hand during Auto Loading. - When the error indication remains after loading, try to load again. If the error indication still does not turn off after pressing for a few times, consult your Alpine dealer. • Scratched disc, contaminated disc/poor recording/disc incompatible with this unit. - Touch [ ] of DISC on the EJECT/TILT screen. - Change the disc. • A copy-protected WMA file was played back. - You can only play back non-copy-protected files. • A sampling rate/bit rate not supported by the unit is used. - Use a sampling rate/bit rate is supported by the unit. 66-EN